|
Instructions
for the installation and adjustment of the TREE TOP
sight:
Carefully
read all instructions before beginning.
-
Mount the sight aperture bracket to the middle of
the windage bracket.
- Mount
the assembly from step 1 to the bow mounting bracket.
- Mount
the final assembly to the bow using the two mounting
screws.
- Adjust
the windage bracket to 1/8" left of center shot
(for right handed bows).
Adjustment
of sight:
- Locate
and tighten the stop at the end of the slot. #1
- Locate
and tighten the stop at the middle of the slot. #2
- Get
close to the target and shoot the first arrow.
- Set
the sight to be on target at 20 yards from ground
level. Move the sight body right or left for windage
and up or down for elevation adjustments.
- Re-adjust
the sight for desired tree stand elevation at a target
20 yards from the stand.
-
After tree stand elevation adjustment, return to ground
level and shoot again at 20 yards. If needed, a fine
adjustment may be required by adjusting Stop #1.
Special
Note:
The
Tree Top sight is unique in that the user can fine adjust
the sight pin for either fast or slow bow setups. To
make the fine adjustment, remove the Light Guard. Then
loosen the set screw in the middle of the pin spool
3 turns and pull the pin outward. On the inside of the
pin spool, there are graduations for fine adjustment.
For faster bow setups, rotate the pin to the right (clockwise)
or towards the shooter. For slower bow setups, rotate
the pin to the left (counter clockwise) or away from
the shooter. After adjustment, tighten the screw in
the middle of the pin spool, replace the Light Guard
and re-shoot the target.
|
|
